• Intended for use only with dielectric frames and hard hats.
• Not intended for use in areas where energy levels may exceed 13 cal/cm².
• Visors should always be worn with primary eye protection such as high impact-resistant spectacles or goggles. Visors should be inspected frequently and replaced immediately if worn, scratched, or damaged in any way.
• Injection-molded visor includes an antifog coating.
• Meets NFPA 70E, ASTM F2178.
• Meets ANSI Z87.1-2003 high-impact standards.
• CAUTION: Selection of proper models for specific hazards and communication of all instructions, precautions, and limitations to the wearer is the responsibility of user safety specialists, who are also responsible to see that they are strictly observed. Failure to comply with any of the above could result in serious injury or death.
• WARNING: Do not use MSA visors for welding, elevated temperature applications, or for protection against other infrared radiation sources unless the MSA visor is approved for such applications. Do not use for sports, simulated war games, paintball games, or similar activities. A pitted or scratched visor reduces eye protection and vision. Inspect routinely and replace worn or damaged parts immediately. Do not alter or modify this product. Do not use near open flame. Failure to follow these warnings can result in permanent impairment of sight, other serious personal injury, or death.

Estimated Shipping Charges: We have estimated Shipping Charges based on the Order Subtotal. Actual shipping charges will be applied to your order once the order is processed and actual weights are known.

Click Here for Shipping Info